History Size Command on CISCO Router/Switch

  • Post category:IOS Commands Help
  • Post last modified:July 9, 2020

Command History Size Use Sets the number of previous commands stored in the session history. These commands can be viewed by pressing the up arrow key. Syntax Router(config-line)#history size <0-256> Example…

Continue Reading History Size Command on CISCO Router/Switch

Login Command on CISCO Router/Switch

  • Post category:IOS Commands Help
  • Post last modified:July 9, 2020

Command Login Use Enables authentication for virtual terminal connections to router. Contrary to what it may sound like, using the no login command will actually disabled authentication to the vty line. This…

Continue Reading Login Command on CISCO Router/Switch

Logging synchronous Command on CISCO Router/Switch

  • Post category:IOS Commands Help
  • Post last modified:July 9, 2020

Command Logging Synchronous Use When enabled on a virtual terminal, logging synchronous causes all router status messages to be displayed on a new line. Syntax Router(config-line)#logging synchronous Example For this…

Continue Reading Logging synchronous Command on CISCO Router/Switch

Privilege Command on CISCO Router/Switch

  • Post category:IOS Commands Help
  • Post last modified:July 9, 2020

Command Privilege Use Sets the privilege level you run at upon logging in through the console. Syntax Router(config-line)#privilege level <0-15> Example In this example, privilege level 15 is used to set the…

Continue Reading Privilege Command on CISCO Router/Switch