Show run Command on CISCO Router/Switch

  • Post category:IOS Commands Help
  • Post last modified:July 12, 2020

Command Show Running-Config Use Shows the current configuration of a device. This is one of the first commands you will enter when trying to understand how a device is configured.…

Continue Reading Show run Command on CISCO Router/Switch

Access-Class Command on CISCO Router/Switch

  • Post category:IOS Commands Help
  • Post last modified:July 12, 2020

Command Access-Class Use Specifies which hosts can telnet/ssh into the vty. Syntax Router(config-line)#access-class <list> <in or out> Options <in>Applies the access-list to inbound traffic on the interface.<out>Applies the access-list to traffic…

Continue Reading Access-Class Command on CISCO Router/Switch

Privilege Command on CISCO Router/Switch

  • Post category:IOS Commands Help
  • Post last modified:July 12, 2020

Command Privilege Use Sets the privilege level you run at upon logging in through vty port. Syntax Router(config-line)#privilege level <0-15> Example In this example, privilege level 15 is used to set the…

Continue Reading Privilege Command on CISCO Router/Switch