Show Hosts Command on CISCO Router/Switch


Show Hosts


This command displays information about the hosts that are configured with the ip hostcommand.


Router#show hosts


In the below example we use show hosts to verify the hosts that are configured on R2.

R2#show host
Default domain is not set
Name/address lookup uses domain service
Name servers are

Codes: UN – unknown, EX – expired, OK – OK, ?? – revalidate
temp – temporary, perm – permanent
NA – Not Applicable None – Not defined

Host Port Flags Age Type Address(es)
R1 None (perm, OK) 0 IP
R3 None (perm, OK) 0 IP